Input Files
Introduction
This is a simple example of the installation of a Rubber O-Ring Seal
Options and Keywords Used
Keyword documentation may be found in the reference guide available from
OpenRadioss User Documentation
/IMPDISP/FGEO Imposed Displacement to a final reference geometry
/INTER/TYPE7 Contact with ‘Tstart’ Time to delay contact start
/MAT/LAW42 Ogden Rubber Material for Seal
Model Description
O-Ring, Seat and Tool
2 Contacts (Tool to O-Ring, and Seat to O-Ring)
...
Units: mm, s, Tonnes, N, MPa
Model Method
The O-Ring starts off inside (and smaller than) the seat in which it is to be installed
...
The contact between the O-Ring and it’s seat is not switched on, until later in the simulation, when the tool is then retracted again allowing the seal to settle back into position
Conclusion
Simple method to pre-position a seal